2,159
edits
Changes
Jump to navigation
Jump to search
Updating to match new version of source page
[[File:RFS UI.png|700px|none|baseline|thumb]]
#[[#anchor1|A/P - AUTO PILOT]]#[[#anchor2|THR - THROTTLE]]
#[[#anchor3|MASTER CAUTION]]
#[[#anchor4|GROUND SYSTEMS]]
#[[#anchor5|AIRCRAFT SYSTEMS]]
#[[#anchor6|FLAPS]]
#[[#anchor7|GEAR - LANDING GEAR]]
#[[#anchor8|SPOILER]]
#[[#anchor9|BRAKE - GROUND BRAKE]]#[[#anchor10|RUD - RUDDER]]
#[[#anchor11|Change PANEL INSTRUMENTS]]
#[[#anchor12|Change CAMERA]]
#[[#anchor14|Planner MAP/FMC]]
#[[#anchor15|PAUSE]]
#[[#anchor16|COMMS- COMMUNICATIONS]]#[[#anchor17|VDGS - VISUAL DOCKING GUIDANCE SYSTEM (VDGS)]]
<br/>
----
<div id="anchor1">'''1. A/P - AUTO PILOT'''</div>
'''[[File:AP.png|400px|none|middle|thumb]]'''
<br />
<br />
<div id="anchor2">'''2. THR - THROTTLE''': Move up/down to set desired engine thrust.</div><br/>
<div id="anchor3">'''3. MASTER CAUTION''': Shows any active alarm. Tap to reset alarms.</div><br/>
Keep the button pressed and move up/down to change flaps settings.
<br/>
<div id="anchor7">'''7. GEAR - LANDING GEAR'''</div>
Press to extend/retract the landing gear. Make sure to have an IAS (Indicated Airspeed) below "VLO" (Maximum landing gear operating speed) in order to extend it.
<br/>
Keep the button pressed and move up/down to change spoilers settings.
<br/>
<div id="anchor9">'''9. BRAKE - GROUND BRAKE'''</div>
Tap to switch on/off the ground brake.
<br/>
<div id="anchor10">'''10. RUD - RUDDER'''</div>
Move left/right to operate the rudder.
<br/>
:* REPLAY: Look at your replay<br/><br/>
<div id="anchor16">'''16. COMMS- COMMUNICATIONS'''</div>
:'''16.1 ATC - Air Traffic Control'''<br/>
: </gallery><br/>
<div id="anchor17">'''17. VDGS - VISUAL DOCKING GUIDANCE SYSTEM (VDGS)'''</div>
Available on any HD Airport. Follow map instructions to reach your assigned gate, then reach the parking area following instructions provided by the VDGS. When correctly parked (OK), the PASSENGER BOARDING BRIDGE will become available.<br/>
<gallery widths="154px" heights="180px" perrow="4">